Make note of this letter, if the incorrect drive is selected in the next step, it can re-write all of the data stored on that drive.

Open up “ My Computer”/”Computer” to check the letter assigned to the SD card you have inserted.

IMG file of the Wheezy Raspian version that you downloaded (Or the RetroPi Image if you downloaded that).

Click on the blue folder to the right of the empty box for “ Image File“.

Unzip the contents of the two downloaded files into a folder, and run “ Win32DiskImager.exe“.

Plug your SD card into your computer via an SD card reader.

Download the latest Win32 Disk Imager from.

Download the latest Raspian Wheezy from.

If you used the RetroPie Image and an older model Raspberry Pi, please skip to the section “Software Configuration of the Raspberry Pi” IF YOU ARE USING A RASPBERRY PI 2 B+ START HERE: Initial Setup Of The Raspberry Pi:įor those who didn’t use the RetroPie Image It will probably look something like “192.168.1.5” – Write this string of numbers down somewhere.īack at the terminal type: sudo raspi-config Take note of your IP address, it is the string of numbers following the line “ inet addr“. We have some other things to take care of, so press F4 to exit EmulationStation. Once your are done with that, you will be presented with the EmulationStation menu. We will come back later and configure it with the controller, but for now, that is not important. Once the Raspberry Pi boots up, it should jump right into EmulationStation and have you map out the controls (keep in mind this does not map controls for the emulators, only the EmulationStation menu) – Just follow through the prompts here. Now power on your Raspberry Pi by plugging it into your Micro USB Power Supply. Now you want to plug your Raspberry Pi into a screen via HDMI, plug in the ethernet cable, and plug in your USB Keyboard. Once you have that image downloaded, you can use Win32 Disk Imager (as detailed in the next section) to mount the image to the card, and then slap it right into your Raspberry Pi.īy doing this, you bypass the (very) long wait to download and compile the emulators, however, the image may not contain the most up-to-date version of the emulators.

Also, don’t forget there is a donate button there if you feel like sparing some change for the creators of this awesome package. To save a lot of time on the installation of RetroPie, you can actually just head over to the RetroPie Download Site, and grab the “RetroPie Project SD Card Image” – Then unzip that file to a location on your primary computer. _ NOW WITH INSTRUCTIONS FOR RASPBERRY PI 2 B+ If you are using a Raspberry Pi A, B, B+ Start here: To find out what you need for this project, please visit the “Materials” page.

3d nes emulator joel highlights